Outpost with Radar Dome (3D Printable Building #3) (updated)

[pascal]

Hey,

This is my next design:



https://www.thingiverse.com/thing:3790824

It has both a mapscale (1.5" hex peek-to-peek) and a heroscape (1.75" hex peek-to-peek) dimension version.
And in both versions there is a typical hex-base variant and a minimal base variant.

All versions have a square cavity in the bottom which accommodates a "standard" 12mm die, in case you want to use multiple outposts as objectives.

This should print fairly well in 2 hours or so.

I'm getting pretty good results at a 0.12mm layer height, with 0.08mm layer height for the top few mm's using Slic3r Prusa Edition's variable layer height feature.

As always, I'd love to see photos posted of it being used in games...

[pascal]

And a small bonus design:



https://www.thingiverse.com/thing:3828545

[Red Pins]

Toolbox or, hmm, bridge support? 

[pascal]

I've been able to print them without any autogenerated supports enabled in the slicer, if that's what you mean?

[Red Pins]

Autocorrect.  I was saying, they could be adapted to pillboxes or bridge supports, too, especially the one without the radar dome.