Author Topic: Hunchback LAM prototype  (Read 900 times)

Cyk0

  • Sergeant
  • *
  • Posts: 188
Hunchback LAM prototype
« on: 20 February 2019, 10:56:05 »
Created as a part of the early prototyping by Doctor Cortland into the area on land-air-mech designs.
The Hunchback LAM prototype was considered enough of a success to initiate the Spectral LAM series program.
Like the Spectral series it was built for VDNI equiped Manei Domini test pilots.
 
It manages to provide a compelling package in addition to being a Trimodal-LAM:
The AC20 is upgraded to a Clan ultra version fed by 2 tonnes extra ammo compared to the original and it is protected by CASE.
The small laser in the head is upgraded to a pulse version to increase anti infantry potential.
The added jump jets give a higher jumping speed than the previous walking speed (not to mention the high speed in the other modes).
The switch to DHS gives it vastly improved heat sinking capabilites even with the removal of 2 sinks.
The 3 tones of fuel in total gives it good endurance for a LAM and the extra fuel is kept in the CASE protected left torso for extra security

All this while matching the armor of the standard hunchback!

The downsides?
In order to achieve its performance it utilized som fragile lightweight materials in the form of composite structure and volatile prototype IJJ's
The CASE protects the mech from destruction, but a left torso blow out will prevent transformation and put the UAC out of action, forcing a withdrawal.
Even though the mech is a speedy jumper now, the actual ground speed has been reduced down to assault levels, which means that it spends most of its time doing fast bounds across the ground. When bounding across the ground the hot pIJJ together with the rapid fire rate of the UAC20 necessitated a removal of the medium lasers since the mech got heat soaked in combat conditions

Code: [Select]
Hunchback LAM

Mass: 50 tons
Tech Base: IS, with Clan weapons
Chassis Config: Biped
Rules Level: Experimental Tech

Chassis: Composite Structure
Power Plant: 150 Fusion Engine
Walking Speed: 32.4 km/h
Maximum Speed: 54.0 km/h
Jump Jets: Prototype Chilton 950  Improved Jump Jets
    Jump Capacity: 150 meters
   
Armor: Standard Armor w/ CASE
Armament:
    1  (CL) Ultra AC/20
    1  (CL) Small Pulse Laser
Manufacturer: Bannock-Braigh Aerospace
    Primary Factory: Terran Blacksite 51
Communications System: Prototype Master's Voice
Targeting and Tracking System: Prototype Master's Sight

================================================================================
Equipment           Type                         Rating                   Mass 
--------------------------------------------------------------------------------
Internal Structure: Composite Structure           83 points                2.50
Engine:             Fusion Engine                150                       5.50
    Walking MP: 3
    Running MP: 5
    Jumping MP: 5 Prototype Improved
    Jump Jet Locations: 2 LL, 2 RL, 1 CT                                   2.50
Heat Sinks:         (IS) Double Heat Sink        11(22)                    1.00
    Heat Sink Locations: 1 LT, 2 LA, 2 RA
Gyro:               Standard                                               2.00
Conversion Equipment                                                       5.00
    Avionics Locations: 1 HD, 1 LT, 1,RT
    Landing Gear:       1 CT, 1 LT, 1,RT
Cockpit:            Small                                                  2.00
    Actuators:      L: SH+UA+LA+H    R: SH+UA+LA+H
Armor:              Standard Armor               AV - 160                 10.00
    CASE Locations: 1 LT                                                   0.50

                                                      Internal       Armor     
                                                      Structure      Factor     
                                                Head     3            9         
                                        Center Torso     16           26       
                                 Center Torso (rear)                  5         
                                           L/R Torso     12           20       
                                    L/R Torso (rear)                  4         
                                             L/R Arm     8            16       
                                             L/R Leg     12           20       

================================================================================
Equipment                                 Location    Heat    Critical    Mass 
--------------------------------------------------------------------------------
(CL) Small Pulse Laser                       HD        2         1         1.00
(CL) Ultra AC/20                             RT        7         8        12.00
2 extra Fuel tanks                           LT        0         2         2.00
@Ultra AC/20 (20)                            LT        -         4         4.00
                                            Free Critical Slots: 6

BattleForce Statistics
MV      S (+0)  M (+2)  L (+4)  E (+6)   Wt.   Ov   Armor:      5    Points: 13
3/1j       4       4       0       0      2     0   Structure:  2
Special Abilities: LPRB, RCN, CASE, SRCH, ES, SEAL, SOA
« Last Edit: 21 February 2019, 03:12:28 by Cyk0 »

packhntr

  • Lieutenant
  • *
  • Posts: 1246
Re: Hunchback LAM prototype
« Reply #1 on: 20 February 2019, 12:12:43 »
Nice, but yeah, she's a bit of a glass canon..... nasty when it hits though
If at first you don't succeed, make it worth the repairman's time!

Gigastrike

  • Master Sergeant
  • *
  • Posts: 213
Re: Hunchback LAM prototype
« Reply #2 on: 26 February 2019, 12:14:53 »
Why not just go all the way and make an UrbanLAM?

Cyk0

  • Sergeant
  • *
  • Posts: 188
Re: Hunchback LAM prototype
« Reply #3 on: 26 February 2019, 15:06:31 »
Why not just go all the way and make an UrbanLAM?
Haha
I like the way you are thinking  ;)
The biggest issue with that is that you basically cant free more space by making it slower on the ground... So it would be even more... "challanged"

grimlock1

  • Captain
  • *
  • Posts: 2087
Re: Hunchback LAM prototype
« Reply #4 on: 28 February 2019, 11:34:25 »
Haha
I like the way you are thinking  ;)
The biggest issue with that is that you basically cant free more space by making it slower on the ground... So it would be even more... "challanged"
Would and even slower urbie LAM even be fast enough to take off in Airmech mode?
I'm rarely right... Except when I am.  ---  Idle question.  What is the BV2 of dread?
Apollo's Law- if it needs Clan tech to make it useable, It doesn't deserve those resources in the first place.
Sure it isn't the most practical 'mech ever designed, but it's a hundred ton axe-murderer. If loving that is wrong I don't wanna be right.

KaiserDunk

  • Master Sergeant
  • *
  • Posts: 255
Re: Hunchback LAM prototype
« Reply #5 on: 28 February 2019, 23:35:11 »
Well, I guess it is true that you can make anything fly given enough thrust.   A Hunchback LAM is proof of this.

Cyk0

  • Sergeant
  • *
  • Posts: 188
Re: Hunchback LAM prototype
« Reply #6 on: 02 March 2019, 11:16:02 »
Well, I guess it is true that you can make anything fly given enough thrust.   A Hunchback LAM is proof of this.
Personally, Id be really concerned about letting rip with the the of bore UAC20 in flight