So here is something I set up-
Working on making a towed artillery or field gun piece- so its a WIP.
You can see a Po Heavy Tank in the picture for the scale.
What did I use? Pretty simple . . . one toothpick, cut off the points (which might become shells) though I used one end with a bit of thinning to fit the muzzle break detail. The muzzle break is a hollow Q-Tip tube, wife complained about the type, dog found it and chewed up the ends . . . so I found it on the floor and clipped off the chewed on parts while I was cleaning up. The mounting frame is a matchstick like bit of hobby wood you can get at WalMart, only used part of one so far for the mount & the block after the barrel portion. The frag/blast shield was a bit clipped from gift card that I was using to make some hexes- decent plastic was all that was required and the Xacto knife to trim out the breech/block square portion. I will angle more of that single bit of squared off balsa to finish making the frame. Right now I am looking for some material, either some throw away item or perhaps some hobby bit to make the wheels which will not be functional.
I finally found things for the wheels, they are beads from a craft store. I had to check a few to find ones that were in the proper scale.
This will eventually be set on a base with proper flocking and a paint job of olive green.