BattleTech - The Board Game of Armored Combat

Catalyst Game Labs => BattleTech Game Rules Questions => Topic started by: shopsmart on 05 January 2024, 22:16:17

Title: (Answered) BA vs inferno kill randomization vs damage assigned and killed
Post by: shopsmart on 05 January 2024, 22:16:17
So 3 infernos kill one BA in a unit.  Had a situation where 9 infernos hit.  Randomization resulted in rolls of 2, 2, and 2...  Does that mean that 2nd trooper just "absorbs" the 2 other killsl like damage hits?  Or 9 infernos = 3 dead dead DEAD suits?

BA damage TW pg 219 says to randomly assign damage, with excess on damage hitting alive at the beggining of the turn troopers results in wasted damage... but infernos aren't damage, but randomly assign death TW 141-142.

I can see it going both ways.

If randomly assigned inferno hits kill outright 3 troopers, then what about troopers killed that round via damage?  Do they possibly "absorb" one of the inferno deaths coming?
Title: Re: battle armor vs inferno kill randomization vs damage assigned and killed
Post by: Sartris on 05 January 2024, 22:28:46
Note the rules for infernos on pg 141:

Quote
Infantry: After all inferno attacks against an infantry unit have been resolved for the turn, add together the total number of inferno missiles that struck the unit. Every missile that strikes a conventional infantry unit automatically eliminates three troopers; every three missiles that strike a battle armor unit automatically eliminate one randomly determined trooper (unless the unit mounts fire resistant armor; see Fire Resistant Armor, p. 228). In neither case is this further modified by terrain or infantry type.

Infernos don't care about hitting specific troopers - they hit the unit (Squad, Point, Level I). So nine infernos would kill three battle armor troopers, randomly selected. If a non-multiple of three infernos hit, the remainder are wasted (eg 4 hits would kill one trooper with the fourth hit doing nothing)
Title: Re: battle armor vs inferno kill randomization vs damage assigned and killed
Post by: shopsmart on 05 January 2024, 23:07:52
Not quite answering but answering.  Still confused.  You say infernos don't care about what troopers they hit.  I get that.  I fully understand that the amount of infernos hits on the unit results in the number of dying troopers.  I am trying to figure out how many troopers die due to randomization and if an alive trooper at the beginning of the turn that died from damage also,may,etc absorb those kills.  Also awnser doesn't take into account damage.  Randomness is being applied.  Lets try again...  Also running on 3 hours of sleep...

Ex 1.
9 infernos hit.  Thus 3 BA are killed via randomness.
  A.  3 BA die regardless.  Reroll the "selected" troopers until appropriate dead =3 (thus 2, 2, and 2 rolled would result in 2 rerolls until ther are 3 dead troopers)
  B.  3 BA die, randomize per rules.  Thus 2, 2, and 2 results in only trooper #2 dead because of randomness and thus 2 wasted rolls.

Deeper depending on answer....

Do troopers that died from damage factor into this?

Ex 2.
9 infernos hit, 10 damage was assigned this turn that resulted in killing trooper 2 (alive at the beginning of turn)
 A.  3 BA die, randomize.  Regardless of damage in the end...  Three die in addition to damage kills.
 B.  3 BA die, randomize.  Apply deaths to those that were alive at the beginning of the turn.  Also following above answer.
 C.  Can't think of too tired...

Title: Re: battle armor vs inferno kill randomization vs damage assigned and killed
Post by: Sartris on 06 January 2024, 11:48:36
Ex 1: A
Ex 2: A